Stanrose Envirotech India Private Limited

Surface Preparation
Suitable methods are sanding or grinding. Any surfaces that have been contaminated with oils may also require chemical cleaning. Use an industrial vacuum that picks up even small dust particles. The floor must be cleaned of all dusts and residues before starting to prime. Otherwise you will have various particles trapped within the coat and adhesion will be significantly weakened. The less micro-dust on the surface the less primer you will need. For thin cracks it may be necessary to slice them with a cutter before filling in order to improve the anchoring of the grout. Mix Part A and Part B of Staroxy 103 MOT with Electric Stirrer. Once parts A & B have been thoroughly mixed, the product may be thinned to aid application. Apply the primer coat by brush and then roll the centre with a short nap roller.

Primer
Allow a drying time of at least 4 hours before applying basecoat. If you intend to install epoxy corner coving, this should be done before commencing the next step.

Basecoat
The base coat used is usually Staroxy UL. Mix Part A and Part B ofthe Staroxy UL in a clean bucket with Electric Stirreraccording to the instructions on the technical datasheet. Starting at the far corner, apply the basecoat by trowel and roller and evenly broadcast the Sand if necessary, into the wet product until all the basecoat is covered, except at the leading edge.

Topcoat
It is important to select a suitable topcoat which will meet all the visual and wearing requirements. Mix the topcoat usually Staroxy SL 1000 as per the instruction liter. Remove the perimeter tape and protect the floor from full traffic for 7 days.